Reference nr B-23930

SIPA ECS 6000/24  PET INJECTION -BLOW MOULDING, Year 1997, Capacity 6000 bph, for PET 0.5 - 1 lt and  1.5 lt. In very good conditions, still connected to the line - In production till end of June 2007. Possible to buy also the auxiliaries:  compressor is complete of tank, air dryer MTA, water cooler etc.  PRICE EX WORKS: EURO 90.000, as is - where is. Immediately available.

Make: SIPA
Type: ECS 6000/24
Year: 1996/1997

Production : the machine is running at one side with 0,5 liter bottle and the other side 1,5 liter bottle. They can run together. As option there is the possibility to install another blow mould for 1 liter bottle using same preform of 1,5 liter bottle.

Technical data :

- nr of cavity 24
- nr of injection mould 4
- nr of blow mould 2
- nr of blow cavity 12
- nr of blow mould 2
- nr of cavity per injection mould 6

Dimensions :
- machine dimensions : 11,5 x 4,2 mt x h 3,2 mt
- machine weight : 38 Tons

Electric power :
- power for mechanical movement 160 Kw/h
- power for heating 95 Kw/h
- total power installed 255 Kw
- total power adsorbed 150 Kw/h **
- tension 380 Volt x 3 phase - Hz 50

Compressed air :
- for mechanical movement 30 Nmc/h
- pressure 8 bar

Blowing compressed air :
- for 0,5 liter bottle 295 Nmc/h
- for 1,5 liter bottle 485 Nmc/h
- pressure 35/40 bar

Mould cooling :
- cooling power 70.000 Kcal/h **
- water volume 35 mc/h
- inlet temp. 10°C
- pressure water 4,5 bar

Oil cooling :
- cooling power 65.000 Kcal/h **
- water volume 13 mc/h
- inlet temp. 18°C
- pressure water 4,5 bar

** NOTA : depend from the type of bottle in production

Production of machine based on 1,5 liter bottle 4.800 / 5.500 bph


The machine is now still installed and can be inspected. In about one month about the machine will be take off (dismantled and stocked). The available is the machine complete of platform, dryer, air dehumidifier system, pet loading system, blow mould.

It is possible to buy also the compressor and water chiller.

 

 

---